Centrale des maths - centraledesmaths.uregina.ca
Dilemmes & doutes
« D & D »
 Sujet: range hood
nouvelle recherche

2 articles trouvés pour ce sujet.

 Page1/1
 A range hood 2017-12-04 Chuck pose la question :I'm building a custom range hood and can't seem to get the angles correct where the front and side panels intersect. I saw a similar post but there's no way I can do the calculations for a Wolfram Alpha! Here are the dimensions that I have (in inches)... Base - Front 29 7/16" x side 19 3/16" Top - Front 10" x side 9" Front Panel Length (from base to top on an angle) 21" Side Panel Length (from base to top on an angle) - 17 9/16" Vertical distance from the base to the top 14 1/4 inches. Any help finding the bevel/miter of the two front corners where the sides meet the front panel would be greatly appreciated. I will need the angle for the saw in degrees. Thank you in advance! Regards, ChuckHarley Weston lui répond. Building a custom range hood 2011-10-08 Bill pose la question :I'm building a custom range hood for a customer with special order material that matches their newly installed cabinets and I need it to be perfect. The hood is basically a pyramid but the 4th side is the flat wall at the back and a flat, rectangular top. I need to calculate the bevel and miter of the three sides but I never was very good with geometry functions (although I am fairly good with other math fields). I either need the calculations from you at least (shudder) a formula or set of formulas so that I can calculate them myself.Harley Weston lui répond.

 Page1/1

 Centrale des maths reçoit une aide financière de l’Université de Regina et de The Pacific Institute for the Mathematical Sciences.
 Qui sommes-nous :: carte du site :: our english site